Influence of laser parameters on the surface morphology of slurry-based Al2O3 parts produced through selective laser melting

Abstract

PurposeThe purpose of this paper is to obtain high-performance ceramics and enrich additive manufacturing of ceramic parts. Also, a new manufacturing technique based on slurry by selective laser melting (SLM) was studied, which has some significant advantages compared to indirect selective laser sintering of ceramic powders.Design/methodology/approachTo study the effect of laser parameters on the surface morphology and melting state of pure Al2O3 ceramics, laser power varied between 100 and 200 W and scan speed varied between 60 and 90 mm/s.FindingsExperimental results show that Al2O3 slurry melts completely when the laser power is about 200 W and the scanning speed is 90 mm/s. Surface quality cannot be improved effectively by changing the scanning speed. However, surface quality improves when the laser power is 200∼205 W and energy density is 889∼911 J/mm3. Thermocapillary convection was observed during SLM. By changing the temperature gradient, streak convection and flowing Bénard cells were obtained during SLM of Al2O3 slurry.Originality/valueIt is feasible to produce slurry ceramic parts without binders through SLM. Increasing the laser power is the most effective way to fully melt the ceramics. Complex thermocapillary convection was observed during this new process; it may be used to produce crystals.