Defect recognition in Ti-6Al-4V fabrication by in situ monitoring of directed energy deposition using a laser beam

Abstract

Purpose This paper aims to investigate the relationship between in situ monitoring characteristics and surface defects in laser-based directed energydeposited Ti-6Al-4V. Design/methodology/approach In situ monitoring was conducted to extract and quantify the monitoring characteristics of each frame. A two-dimensional contour map was generated using the quantified characteristics to determine the defect formation locations. Computational thermal-fluid dynamics software was used to determine which surface tension terms or shielding gas had a significant effect on the depression of the molten pool. Findings This study has made a significant contribution by revealing the direct correlation between the molten pool size and brightness with defect formation in laser-based DED of Ti-6Al-4V. It was found that in regions of reduced height, the molten pool exhibited increased size and brightness, leading to surface depressions due to vapor recoil pressure flattening the molten pool. Moreover, the results highlighted that the enhanced Marangoni forces, caused by a high-temperature gradient, hindered the proper accumulation of molten metal, exacerbating height reductions. This insight provides a deeper understanding of how molten pool dynamics directly influence surface quality, which is a critical factor in DED processes. Originality/value This study contributes to understanding of the relationship between in situ monitoring characteristics and surface defects in laser-based directed energy-deposited Ti-6Al-4V. Additionally, by using in situ monitoring and computational analysis, significant insights were gained into the factors influencing molten pool behavior and subsequent surface defects.