Influence of Infill Level and Post-Processing on Physical Parameters and Betaine Content of Enriched 3D-Printed Sweet Snacks.

Abstract

Betaine is a non-essential amino acid with proven functional properties and untapped potential for cereal food enrichment. While 3D printing represents a viable approach for manufacturing enriched cereal-based foods with novel shapes and textures, it is crucial to consider the impact of printing parameters and post-processing on the betaine content and properties of these products. The aim of this study was to investigate the influence of the infill level (20, 30 and 40%) of 3D-printed cuboid shapes and the post-processing techniques (drying oven, vacuum dryer, air fryer) of betaine-enriched oat-based snacks on the print quality, texture, and sensory properties, as well as the content of preserved betaine. The interaction of post-processing technique and infill level influenced the length deviation and texture properties, as well as the betaine content of snacks. Height stability was only influenced by post-processing technique. In general, oven-dried snacks showed the best dimensional stability, having the lowest width/length deformation (about 8%) at the infill level of 20%. Betaine was best preserved (19-31% loss) in snacks post-processed in a vacuum dryer (1281-1497 mg/g), followed by an air fryer and a drying oven, where betaine loss was in the range 28-55%. Air-fried snacks with 40% infill level had the highest values of instrumentally measured crunchiness (38.9 Nmm) as well as sensory test values for liking of texture (7.5), intensity of odor (6) and overall flavor (6). Overall, air frying proved to be a convenient and quick post-processing technique for 3D-printed snacks, but infill patterns for preserving betaine should be further explored. Vacuum drying could be used to preserve bioactive compounds, but efforts should be made to minimize its negative impact on the physical deformations of the 3D-printed products.