Influence of hydrogen volume/specimen surface area ratio on hydrogen embrittlement sensitivity of X52 pipeline steel

Abstract

In the transition towards green energy, long distance transportation of gaseous hydrogen by pipeline is considered to be an economically attractive solution. For safe transportation of hydrogen, it is important to conduct relevant mechanical tests in representative hydrogen environments and working conditions of pipelines to demonstrate acceptable hydrogen embrittlement resistance of the steel. One important issue is the testing condition for the ratio of gaseous hydrogen volume over specimen surface area required in mechanical testing since this has not been specified in any testing standards and codes or investigated. This study investigated this issue by performing slow strain rate tensile (SSRT) testing of an X52 pipeline steel in gaseous hydrogen with different ratios of hydrogen volume/specimen surface area, Rv/s, ml/mm2. It was found that, with increasing Rv/s ratio, the area reduction of the steel decreased and hydrogen embrittlement sensitivity increased in the range of the Rv/s ratios investigated. The saturating Rv/s ratio appeared to be ∼2.0 beyond which the effect of Rv/s ratio on hydrogen embrittlement sensitivity was relatively small. The macroscopic and microscopic observations on both the fracture and side surfaces of the SSRT tested specimens also found that the tendency to cleavage fracture increased with increasing Rv/s ratio. The results of the ab initio molecular dynamics (AIMD) simulations performed also predicted a dependence of hydrogen embrittlement on hydrogen volume when Rv/s ratio is relatively small.