Influence of highly dispersed phase of titanium carbide on physical and mechanical properties of alloys AM4.5Kd and AK10M2N

Abstract

Listen

Translate article

Dispersion-strengthened composite materials belong to the group of promising structural materials characterized by a diverse combination of properties. The work presents examples of the creation and heat treatment of composite materials based on aluminum alloys, strengthened by a dispersed phase of titanium carbide, and characterized by high hardness, elastic modulus and good wettability by the melt. The most accessible, inexpensive and effective way to obtain them is self-propagating high-temperature synthesis (SHS).The work shows the possibility of obtaining new aluminum matrix composite materials based on industrial aluminum alloys AM4.5Kd and AK10M2N by reinforcing them with 10 wt.% highly dispersed titanium carbide or AM4.5Kd–5.95 vol.% TiC and AK10M2N–5.78 vol.% TiC. The reinforcing phase is formed in alloy melts using the technology of SHS from the initial elemental components—titanium powder and carbon black. Using the obtained samples, an assessment was made of the uniformity of the ceramic phase distribution over the volume of the matrix alloys, which amounted to 0.15 and 0.12 for the samples AM4.5Kd–10%TiC and AK10M2N–10%TiC, respectively, which constitutes a high degree of uniformity.An assessment was made of physical properties such as porosity, density, electrical conductivity, as well as the coefficient of thermal linear expansion. Analysis of the data allows us to say that the final composite materials AM4.5Kd–10%TiC and AK10M2N–10%TiC have a slightly higher density (↑~4%) than the matrix alloys, due to the presence of a ceramic phase, low porosity values (~1%), lower TCLE (↓~6%) than matrix alloys and low electrical conductivity (~25% IACS). This article also presents data on the values of the mechanical properties of composite materials AM4.5Kd–10%TiC and AK10M2N–10%TiC. It has been shown that reinforcement with a ceramic phase contributes to a significant increase in hardness by 15 and 42 HB, as well as higher values of the compressive yield strength by 31 and 17 MPa, respectively, while maintaining a high level of relative deformation. The results obtained allow us to conclude that the developed composite materials can be recommended for products used under conditions of elevated temperatures and significant wear.