Abstract
Magnetic properties of sheets of electrical steel with different permeability, grain size and silicon content were measured before and after cutting into strips. Cutting caused a reduction in permeability and the degraded area close to the cut edge. Silicon content was less influential than the grain size. The degraded area was found to be up to 15 mm depending on the type of material.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
