Abstract
Evaluate the impact of printing parameters on flexural strength (σ), flexural modulus (E), precision, and surface topography characteristics of a resin used to produce provisional restorations. 450 bars for provisional restorations were printed using the SLA printing (25 × 2x2mm ISO-4049), and randomly divided into 30 groups (n = 15) according to the following factors: "printing layer thickness" (25μm;50μm;100μm), "Build angle" (0°,30°,45°,60°,90°) and "thermocycling-TC" (with or without). Following printing, the samples underwent cleaning with isopropyl alcohol. Photopolymerization was performed for 15min with an UV lamp. Subsequently, each bar was assessed using a digital caliper at 11 specific points in three dimensions for comparison with the STL file area for precision analysis. Half of the samples underwent thermocycling. All samples were submitted to the σ test. Data for σ (MPa), and (GPa) and precision (mm) were analyzed using 3 and 2-way ANOVA, respectively, and Tukey's post hoc test (5%). Micro-CT, 3D profilometry, and SEM were also performed and analyzed descriptively. The 90°/25μmTC (63.0 ± 4.5) showed the highest σ, being only statistically similar to the 45°/25μmTC (57.7 ± 3.1). For precision 0°/25μm (-2.56 ± 0.04) expressed the greatest variation to the other experimental groups with a sample shrinkage of 25.6% compared to the STL file. The profilometry revealed that the 30º/25μm group showed prominent peaks and valleys, presenting elevated roughness values with an average of Sa (28.25μm). Moreover, it was observed that the groups with a 60° angle presented the lowest porosity values. A print layer thickness of 25μm combined with a build angle of 90º and 45º resulted in higher σ and greater precision.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call