Influence of A-Site Modifications on the Electrical and Crystallographic Properties of Ln0.2Sr0.7-XCaxTi0.95Fe0.05O3-δ (Ln=La, Nd) Based Fuel Electrode for Solid Oxide Cell

Abstract

Perovskite oxides, in particular SrTiO3–based compounds have attracted particular attention over the past years due to their decent conductivity, good dimensional stability and high tolerance and resistance towards sulfur poisoning and carbon depositions [1, 2]. Optimal doping and stoichiometry levels on A- (La, Nd etc.) and B-sites (Fe, Ni etc.) of SrTiO3 based compounds allow to improve catalytic activity, electrical conductivity and chemical stability [2]. In addition, doping of A-site with calcium is predicted to enhance the electronic conductivity because it should decrease the unit cell volume bringing the conduction orbitals of titanium closer to each other [3].In this research influence of chemical composition of A-site on electrical and electrochemical performance of Ln0.2Sr0.7-xCaxTi0.95Fe0.05O3-δ (Ln=La, Nd) (x=0.35, 0.45) (LSCTF-x, NSCTF-x) hydrogen electrode has been investigated. The crystal structure and microstructure have been studied using X-ray diffraction and SEM to confirm the phase purity and visualize the microstructure of studied electrode layers. To understand the influence of MIEC material composition on electrical conductivities of LSCFT and NSCTF, the DC four-probe conductivity measurements of porous electrode layers has been performed. Conductivities have been measured at two different atmospheres: 1% H2 + 3% H2O + 96% Ar and 97% H2 + 3% H2O. It has been shown that the both LSCTF and NSCTF materials behave like semiconductor and the conductivity is significantly dependent on composition. The maximal total electrical conductivity of porous electrode layers were 5.5 S cm− 1 and 4.8 S cm− 1 at 850 °C characteristic for the La0.2Sr0.25Ca0.45Ti0.95Fe0.05O3-δ (LSCTF-45) and Nd0.2Sr0.35Ca0.35Ti0.95Fe0.05O3-δ (NSCTF-35) materials, respectively, in 97% H2 + 3% H2O atmosphere. Keywords: solid oxide fuel cell; perovskite; fuel electrode; MIEC; LST. [1] X. Li, H. Zhao, X. Zhou, N. Xu, Z. Xie, N. Chen, Electrical conductivity and structural stability of La-doped SrTiO3 with A-site deficiency as anode materials for solid oxide fuel cells, international journal of hydrogen energy 35 (2010) 7913-7918.[2] A. Gondolini, E. Mercadelli, G. Constantin, L. Dessemond, V. Yurkiv, R. Costa, A. Sanson, On the manufacturing of low temperature activated Sr0.9La0.1TiO3-δ-Ce1-xGdxO2-δ anodes for solid oxide fuel cell, Journal of the European Ceramic Society, 38 (2018) 153–161.[3] A.D. Aljaberi, J.T.S. Irvine, Ca-substituted, A-site deficient perovskite La0.2Sr0.7TiO3 as a potential anode material for SOFCs. J. Mater. Chem. A 2013, 1, 5868-5874.