Abstract
Accessing nowadays fossil fuel reserves requires a strain-based design approach. Within suchdesign, the ductile tearing resistance is a key parameter in assessing the defect tolerance. To determinethis tearing resistance, full scale (pressurized) tests can be performed. However, such approach would becostly and time consuming. Consequently, effort is made to select appropriate small scale test specimens.Most research has focused so far on the single edge notch bend (SENB) and tensile (SENT) specimen. Toevaluate the suitability of these test specimens, the crack tip stress fields can be examined or theresistance curves compared with full scale structures. This paper aims at comparing the trends observedusing these techniques. Furthermore, the suitability of the small scale test specimens is evaluated. It isconcluded that sufficiently long (length-to-width ratio equal to ten) clamped SENT specimens have thepotential to predict the tearing resistance of full scale pipes. In addition, the internal pressure does notsignificantly affect the fracture toughness. These conclusions are stated by both experimental results andfinite element simulations.
Published Version (
Free)
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal Sustainable Construction & Design
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
