Abstract
Friction spot welding is a recent solid-state welding technique well suited for spot-joining lightweight materials in overlap condition. Aerospace and transport industries show great interest in this technique to join high-strength aluminium alloys, but published research is still limited. In this project, the link between process parameters and weld quality is investigated for EN AW-7075-T6 material. Techniques used are metallographic qualification, measurement of hardness reduction and lap shear strength. This paper focusses on the metallographic investigation of the weld region and its imperfections. Increasing joining time and heat input creates an easier material flow resulting in fewer imperfections. Limited plunge depths lead to typical interface imperfections. Variation in the rotational speed shows distinctive stir zone shapes as a consequence of severe stirring and frictional heat.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal Sustainable Construction & Design
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
