In Situ Stress Generation during Oxygen Evolution and Reduction Reactions on Au Positive Electrode in Li-O2 Batteries

Abstract

Li-O2 batteries have received enormous interest from the scientific community due to its extremely high theoretical specific energy density, which is originated from the oxygen reduction reactions during discharge at the surface of the cathode electrode. Unfortunately, the commercial implementation of this technology is hindered by the poor cycling performance, mostly due to the sluggish oxygen evolution/reduction kinetics and the nature of the discharge reaction product. The lithium peroxide (Li2O2) is the discharge reaction product and its insulating nature limits to harvest the theoretical capacity of the Li-O2 batteries practically. The impact of the salt and solvent species on the formation mechanisms of the discharge product has been reported widely. However, underlying mechanisms dictating the reaction pathway is still under debate.In this study, we employed in situ stress measurement to investigate the impact of the electrolyte salt on nanoscale dynamic changes on the surface of the thin Au film cathode (1-D) during charge / discharge of Li-O2 batteries. Stress measurements have been applied to various electrochemical and electrocatalytic application areas in order to probe the dynamic changes on the surface of the materials. The electrolyte was prepared by mixing 1 M LiTFSI or LiNO3 salts in DMSO or Diglyme solvents. Electrolytes were saturated either with oxygen or argon prior to performing electrochemical measurements. In situ stress measurements were conducted using a multiple beam optical sensor (MOS). A custom cell was designed to monitor the physical response of the cathode during cycling while enabling optical access to the back of the substrate for stress measurements1. In situ curvature evolution on Au thin film cathode was monitored during discharge and charge via galvanostatic cycling and cycling voltammetry.In this talk, we will present the impact of the electrolyte salt on the potential-dependent surface stress generation during the formation and oxidation of electrochemical redox reaction products at nanoscale on the Au thin film cathode. Shortly, in situ stress measurements pointed out the contribution of charge-induced stress, electrostriction stress, and intrinsic stress associated with the formation of discharge reaction products. Revealing the mechanical response of the discharge products on cathode electrode will shed light into the formation mechanisms of these products, which is crucial to design new electrolyte and cathodes for Li-O2 batteries.Acknowledgement:This work was supported by the Binational Science Foundation (#2018327), and we are thankful to both Dr. Malachi Noked and Rosy for fruitful discussions.