Impact of Denture Cleansing Solution Immersion on Some Properties of Different Denture Base Materials: An In Vitro Study

Abstract

To evaluate the effect of several denture cleansing solutions on the color stability, surface roughness, and flexural strength of three denture base materials. Twenty-seven specimens were prepared using heat-polymerized (HP) denture base material, 27 using autopolymerized (AP) denture base material, and 27 using visible-light-polymerized (VLP) denture base, creating a total of 81 specimens. The specimens were randomly divided into three groups (n = 27): the distilled water group (DWG), Corega group (CG), and Renew group (RG). Color changes (ΔE), surface roughness (Ra, nm), and flexural strength (MPa) of each specimen were measured using a spectrophotometer, an optical profilometer, and a universal testing machine, respectively. The results were statistically analyzed using a one-way ANOVA and a post hoc Tukey's test (α = 0.05). The only statistically significant color change detected was in the VLP resin treated with Corega and Renew. There was a significant increase in the surface roughness of all denture resin groups after immersion in Corega. Immersion in Renew significantly increased surface roughness only in the HP and AP specimens. The only significant reduction in flexural strength was detected in the HP resin after immersion in Corega (p < 0.05). Within the limitations of this study, it can be concluded that Corega has a significantly greater negative impact than distilled water on the flexural strength of HP resin base materials. Renew significantly increased the surface roughness of AP and HP, while Corega increased the surface roughness of all resin materials.