Abstract
AbstractSeveral new tool steel grades as well as optimised modifications of standard grades have been developed by special steel producers during the last one to two decades. These steels offer the potential for better properties and tool performance, but only if the heat treatment is performed with an optimum combination of parameters. The achievement of this potential is supported by advanced heat treatment equipment and processes. This paper gives an overview of the possibilities, requirements and optimum heat treatment parameters of these new tool steels based on the examples of cold work tool steels. Thereby special attention is paid to 8%Cr steels, spray formed steels, powder metallurgy steels as well as surface hardening and cryogenic treatment. A second part will be published successively, with examples on hot work tool steels and tool steels for plastic moulding.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Heat Treatment and Surface Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
