Abstract
This paper describes the design, fabrication, and validation of a paper-based diagnostic device for the rapid diagnosis of hypocalcemia in dairy cattle at the point-of-care (POC). The device incorporates a 3D printed calcium ion-selective membrane (ISM) as the sensing element for free—unbound—calcium in real bovine whole blood samples. With a linear response range of 100 mM to 97.7 μM, the sensor covers the clinically relevant concentrations of Ca2+ associated with both healthy cattle as well as those suffering from hypocalcemia. The components of the Ca2+ ion-selective electrodes were successfully translated to a paper-based device to provide a sensing platform that is simple to use, disposable, and low-cost, and is therefore well-situated for applications at the POC. The paper-based calcium sensor showed a Nernstian response between 10 mM and 100 μM and required only 12 μl of sample to perform a measurement, which can be accomplished in less than two minutes without the need for time-consuming separation steps. The performance of the paper-based Ca2+ sensor was validated using the commercially available epoc® Blood Analysis System, which provided results within 5% of the data obtained with 3D printed Ca2+-ISM integrated paper-based device.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
