Gold-coated Impedance Biosensors on PCB and PET for Real-Time Monitoring of Cancer Cells

Abstract

Abstract Electrical cell-substrate impedance sensing (ECIS) biosensors are widely used for in vitro cancer cell monitoring as they are label-free, require small sample volumes, and allow real-time monitoring. ECIS electrodes are typically made of pure gold, but the usage of pure gold electrodes is too costly for single-use applications. As an alternative, this work proposes the use of gold coatings on a printed sensor's electrodes. The interdigitated electrode design was used on glass fiber-reinforced epoxy resin for printed circuit boards (PCB), and polyethylene terephthalate (PET). The Cu/Ni electrodes on PCB were electroplated with Au, while the Cu/Ni electrodes on PET were coated with Au using an electroless technique. The physicochemical properties were studied using optical microscopy, scanning electron microscopy, and energy-dispersive spectroscopy. Electrochemical characterization was done using cyclic voltammetry and electrochemical impedance spectroscopy. Biocompatibility assessment and sensor functionality tests were done by culturing SiHa cervical cancer cell lines on these sensors and impedance measurements. The results show that both electroplated and electroless sensors were biocompatible and suitable to monitor SiHa cell growth. Electrochemical migration effect was observed on the sensors where the reaction occurred at 1.2V DC for the PCB sensor and 1.0V DC for the PET sensor.