Identification and characterization of the encrusting materials in a coastal liquefied petroleum gas storage cavern

Abstract

An examination was carried out of the encrusting materials on the seepage removal pumps in a bottom sump of an undersea liquefied petroleum gas (LPG) cavern. The studied cavern, constructed at 8 km off the western coast of Korea, facing the Yellow Sea, is at 130–150 m below the seabed. Since the first filling of the LPG into the cavern, it has suffered from the unexpected problem of a thick encrustation of unknown materials on the seepage removal pumps of the cavern. The XRD and XRF analyses revealed that the encrustation materials were mainly iron (hydro)oxides and carbonate mineral (aragonite). Based on the geological setting below the cavern site, it was inferred that iron oxides found in the Pleistocene sandy sediment and the Precambrian gneiss might be supplying ferrous iron to the cavern waters under an anaerobic condition, evidenced by low dissolved oxygen and negative redox potential in the cavern water. A significant change in the hydraulic condition near the pump intake and mixing the cavern water with oxic waters supplied through re-circulated seawater and terrestrial groundwater discharge, would precipitate the dissolved iron. Precipitation of the carbonate mineral is thought to have occurred due to over-saturation of calcium and bicarbonate, which may have resulted from the dissolution of cement grouting materials used during the undersea cavern construction and submarine groundwater discharge (SGD). This study reports the iron and carbonate precipitation in the man-made undersea cavern, which is affected by the surrounding hydrogeological condition and the SGD.