Abstract
Abstract Hydraulic transients occur as a direct result of rapid variations of flow field in pressurized systems. The change in velocity from valve closures or pump operations causes pressure surges that are propagated away from the source throughout the pipeline. The associated pressure changes during a transient period are quite large and occur quickly (within a few seconds). It should also be noted that when the maximum pressures exceed the bar ratings (mechanical strength) of the piping material, failure can occur. Similarly, if the minimum pressure drops below the vapour pressure of the fluid, cavitation can occur. The purpose of the present study is to model and simulate the hydraulic transients in a pipeline network system of the treated effluent rising main of Mpophomeni sanitation scheme using SAP 2R. A total of five scenarios were simulated using different combinations. The simulation results show that the transient pressures in the pipeline exceeded the bar rating of the pipe where the bursts or cavitation may occur for the simulated scenario, but transient pressures were reduced to a safe limit after providing water hammer protection devices.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
