Hydraulic model investigation of downstream erosion of large regulators: a case study

Abstract

Flow conditions, which could not be explained, occurred in the stilling basin and outfall channel of the Feni Regulator sited at the western end of the Feni River closure dam. This regulator controls outflows from the upstream reservoir which supplies irrigation water to Muhuri Project in Bangladesh. Analysis of flood discharge data revealed that the design discharge for the structure was not exceeded; yet abnormal scour occurred in the outfall channel and the brick block rip-rap placed thereon was damaged. A model study was conducted to understand the causes of such unusual local erosion downstream of the stilling basin and to provide answers to two main questions: Using a 1:30 scale model, the probable maximum scour was simulated, and the performance of alternative rip-rap designs including that of the existing one were examined. The results of this study supplemented by field scour data collected during subsequent flood seasons indicated that even if the flow rate through the regulator approaches the design flood discharge, the downstream scour is not likely to extend up to an elevation of − 10.7 m, a scour level observed in the previous year at a lower discharge. It also showed that the existing rip-rap blocks were marginally undersized and consequently the rip-rap was prone to failure if flow conditions departed from uniform. A suitable method of scour protection downstream of the stilling basin at the regulator exit also evolved from the study.