Abstract
The hot deformation behavior and microstructure evolution of as-cast and extruded ZE41A magnesium alloy were studied using processing maps. The compression tests were conducted on both as-cast and extruded alloys in the temperature range of 250–450 °C and strain rate range of 0.001-1.0 s −1 to establish the processing map. The dynamic recrystallization (DRX) and instability zones were identified and validated through micrographs. The extruded ZE41A magnesium alloy shows higher flow stress, higher efficiency and lower instability regimes than as-cast alloy. The extruded ZE41A magnesium alloy achieves good hot workability due to grain refinement, decrease in porosity, hardening and strengthening of the material.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Transactions of Nonferrous Metals Society of China
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.