Similar Papers

Paper Title
Journal
Date
Author
Multiobjective Optimization of Tool Geometric Parameters Using Genetic Algorithm
Maohua Du ... Yanfei Zhang
Complexity | VOL. 2018
Maohua Du, et. al.Maohua Du ... Yanfei Zhang
01 Jan 2018
Optimization of Process Parameters for Laser Cutting Process of Stainless Steel 304: A Comparative Analysis and Estimation with Taguchi Method and Response Surface Methodology
Vi Nguyen ... Thanh Tran
Mathematical Problems in Engineering | VOL. 2022
Vi Nguyen, et. al.Vi Nguyen ... Thanh Tran
21 May 2022
Optimisation of process parameters on thin shell part using response surface methodology (RSM) and genetic algorithm (GA)
J M Faiz ... M H M Hazwan
-
J M Faiz, et. al.J M Faiz ... M H M Hazwan
01 Jan 2017
Automated Response Surface Methodology for Simulation Optimization Models with Unknown Variance
Robin Nicolai ... Rommert Dekker
Quality Technology & Quantitative Management | VOL. 6
Robin Nicolai, et. al.Robin Nicolai ... Rommert Dekker
01 Jan 2009
View more papers

More From: Proceedings of the Institution of Mechanical Engineers, Part E: Journal of Process Mechanical Engineering

Paper Title
Journal
Date
Author
A comparative review of machinability in AA2XXX and AA7XXX heat-treatable aluminum alloys: Focus on AA7050-T7451 and AA2050-T84
Elvan Ates ... Fahrettin Ozturk
Proceedings of the Institution of Mechanical Engineers, Part E: Journal of Process Mechanical Engineering | VOL. -
Elvan Ates, et. al.Elvan Ates ... Fahrettin Ozturk
09 Jan 2025
Geometric parameters optimization of tap via response surface methodology and nondominated sorting dung beetle optimization algorithm
Kunyu Li ... Zhanqiang Liu
Proceedings of the Institution of Mechanical Engineers, Part E: Journal of Process Mechanical Engineering | VOL. -
Kunyu Li, et. al.Kunyu Li ... Zhanqiang Liu
08 Jan 2025
Optimizing laser spot size for improved structural integrity in additively manufactured copper alloy components
M Saravana Kumar ... Che-Hua Yang
Proceedings of the Institution of Mechanical Engineers, Part E: Journal of Process Mechanical Engineering | VOL. -
M Saravana Kumar, et. al.M Saravana Kumar ... Che-Hua Yang
07 Jan 2025
Evaluation of input process parameters in turning operations affecting the thread cutting operation on NIMONIC 80A for dental implant device
Rajagopal Ramkumar ... Thangarajan Sivasankaran Senthilkumar
Proceedings of the Institution of Mechanical Engineers, Part E: Journal of Process Mechanical Engineering | VOL. -
Rajagopal Ramkumar, et. al.Rajagopal Ramkumar ... Thangarajan Sivasankaran Senthilkumar
07 Jan 2025
View more papers

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.