FPGA based Design of Triple Modular Redundancy for Hybrid Digital Pulse Width Modulation Generator

Abstract

This paper proposes the Triple Modular Redundancy checker for the Hybrid Digital Pulse Width Modulation generator to verify the correctness in the output signal. The proposed design involves replicating the Hybrid Digital Pulse Width Modulation Generator thrice and the majority voter circuit validates the correct output by considering the two accurate signals out of the three outputs. The digital pulse width modulation generator is broadly classified as Counter-based Digital Pulse Width Modulation, Delay line-based Digital Pulse Width Modulation, and Hybrid-based Digital Pulse Width Modulation. Among the three methods, the Hybrid based Digital Pulse Width Modulation is preferred as the Counter-based Digital Pulse Width Modulation uses high clocking frequency and the Delay line-based Digital Pulse Width Modulation occupies a large area. The proposed Triple Modular Redundancy is implemented using the FPGA and parameters such as power analysis and device utilization chart.