Abstract

Interlocking bricks are usually produced by mixing laterite clay, fine sand, and Portland cement. However, the typical problem with this mixture is the formation of cracks due to the brittle behaviour of the interlocking materials mixture. Therefore, there is a need to add some fibres that could enhance the strength of the production of interlocking bricks. This paper presents the effects on compressive and flexural strength of interlocking bricks produced by mixing with synthetic polypropylene fibre (SPF) and palm oil fibre (POF). Tests were carried out to compare the relative strength between normal interlocking brick and proposed interlocking brick with fibre. Nine interlocking bricks with various mixture were tested for compression. Three beams specimen were prepared and tested until failure. The results showed that the addition of fibre has significantly increased the strength of interlocking bricks in all tests. POF interlocking bricks showed the highest strength, while SPF interlocking bricks showed higher in compression but lower in flexural strength than normal interlocking brick. It was concluded that the addition of POF in the interlocking mixture could be used as an additive mixture to improve the strength of the interlocking brick system.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.