Abstract
This paper presents the Finite Element Analysis (FEA) of MEMS based capacitive pressure sensor to monitor intraocular pressure. The sensor composed of a square Polysilicon diaphragm that deflects in response to applied pressure. Applied pressure deflects the 2 µm diaphragm, changing the capacitance between the Polysilicon diaphragm and the bottom electrode Si substrate. The square diaphragm produces highest induced stress resulting in high sensitivity. Intellisuite FEA modeling software was used to predict sensor actuation, capacitance output and the avoidance of material failure. The FEA modeling and simulated data results is generated. The simulation of the MEMS capacitive pressure sensor achieves good linearity in the intraocular pressure range. The geometry and dimensions are selected to produce optimal performance of the sensor.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: International Review of Mechanical Engineering-IREME
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.