Abstract
Bi6Fe2Ti3O18 thin film on Pt/Ti/SiO2/Si substrate with a thickness of 85 nm is successfully prepared by a monoethanolamine-modified sol-gel processing. The prepared thin film is polycrystalline and shows dense morphology. The room temperature remnant polarization is higher than 10 μC cm−2 at 5 V driving voltage both from polarization-voltage hysteresis loop and positive-up negative-down measurements. The polarization after 107 switching cycles and a retention time of 104 s shows no obvious degradation, suggesting good fatigue-resistant characteristics. Weak ferromagnetism is observed at 5 K with a saturated magnetic moment of 11.7 emu/cm3. The results will provide an effective route to optimize Bi6Fe2Ti3O18 thin films with thickness below 100 nm by low-voltage driving.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
