Fabrication and characterization of inner selective antibiofouling forward osmosis hollow fiber membranes for simultaneous wastewater treatment and desalination

Abstract

Forward osmosis (FO) hollow-fiber membranes were prepared by in situ thin layer assembly of polyethyleneimine (PEI) on antifouling PES-based porous nanocomposite membranes during membrane formation by spinning and phase inversion, via incorporation of surface-modified silver nanoparticles (NPs) in the dope solution and addition of PEI in the bore liquid; after cross-linking with glutaraldehyde the FO selective layer was obtained at the lumen surface while the shell surface had ultrafilter (UF) properties. This design enabled the utilization of the FO membranes in active layer facing draw solution (DS) orientation to employ maximum effective osmotic pressure, while the UF layer in combination with the antibacterial NPs was supposed to reduce fouling by the wastewater used as feed solution (FS). The quality of the active layer assembly was characterized using atomic force microscopy and scanning electron microscopy analyses, as well as salt rejection, structural parameter (S), and molecular weight cut-off (MWCO) measurements. The separation performance of these membranes was evaluated in an osmotic membrane bioreactor (OMBR) system, showing for the best FO nanocomposite membranes less than 10% fouling and flux reduction over 5 cycles of operation over a total period of 5 days. The best-suited membrane showed promising separation performance in the OMBR system by providing 43.4 LMH water flux and only around 0.2 g/l specific reverse salt flux (SRSF) with 1 M NaCl and DI water serving as DS and feed, respectively. This study focused also on distinctive performance criteria in combined FO and OMBR systems, such as the membrane’s potential in a pretreatment step of brine streams (used as DS) to provide proper feed composition for RO units and introduced a new specific performance index (SPI) for better characterization of FO membranes which summarizes all essential characteristics of the membrane application, instead of using existing structural parameter equations for membrane characterization. The best-suited FO membrane offered an SPI of 778.2 gl−1 m−2 h−1, meaning 778.2 g/l reduction of TDS in DS per unit membrane surface area per hour.