Experimental Study on Surface Electric Field Distribution and Flash-over Voltage of Bushing Composite Insulator at High Altitude

Abstract

At present, the high voltage bushing composite insulator is widely used in AC/DC system substation, and its structural parameters show the nonlinear growth trend with the increase of voltage level. Therefore, in 1000kV UHVAC and 800kV UHVDC system, bushing composite insulator has the typical characteristics of long insulation distance and large radial diameter. At present, with the proposal of high-voltage power equipment compact optimization design scheme, the radial diameter of the composite insulator for bushing can be effectively reduced by reasonable design of internal capacitor core or metal shield structure optimization design scheme, so as to realize its large aspect ratio compact design. On the other hand, the insulation distance of high voltage bushing composite insulator will be further increased when it is applied in high altitude area. The innovation of this paper is how to carry out flashover voltage test to fill the current test data gap. In view of this, this paper first establishes two typical structures of the high voltage bushing composite insulators, including the three-dimensional finite element models of the composite insulators for capacitive core converter transformer bushing and the double-layer metal shield through the wall bushing, obtains the distribution characteristics of typical voltage and electric field under the operating state, and analyzes the local high field strength and corona, the electric field distribution of composite insulators for bushing. Furthermore, the actual flashover tests between large fittings air metal grounding body and large fittings composite insulator metal grounding body are carried out in the laboratory environment, and the quantitative relationship curve between flashover voltage and space net distance is obtained. Based on the above theoretical analysis and test data, the size altitude correction and umbrella skirt contour topology optimization of composite insulator for the UHV AC/DC bushing are carried out. Finally, the DC withstand voltage test and one minute power frequency withstand voltage test are passed, which proves the rationality and effectiveness of the design of composite insulator for bushing at UHV level. In this paper, starting from the typical electric field distribution characteristics of all kinds of composite insulators for bushing, the flashover law is studied for the first time, and the flashover test is carried out in the laboratory to supplement the classical test data. The research results have good theoretical and practical significance for installation, design and operation maintenance of all kinds of composite insulators.