Experimental study on kinetic oxidation of graphite IG-110 by steam

Abstract

Graphite is proposed for use in High-temperature Gas-cooled Reactors (HTGRs) as the fuel matrix, neutron moderator/reflector, and core structural material. One important property of nuclear grade graphite is their resistance to oxidation in high-temperature environment. Extensive investigation has been performed in the literature for graphite oxidation by air. However, available experimental data are still limited for graphite oxidation by steam under conditions comparable to a postulated steam ingress accident in HTGRs. In this study, the oxidation rate of graphite IG-110 by steam in helium flow was measured at temperatures from 850 to 1100 °C with the steam partial pressure varying from 0.5 to 20.0 kPa and the hydrogen partial pressure varying from 0 to 2.0 kPa. Further analysis confirms the oxidation process in this present study is dominated by the chemical kinetics, which lends credit to the data for being used to develop numerical models. It was observed that the increase of the kinetic oxidation rate with the steam partial pressure tends to become less apparent if the steam partial pressure keeps increasing. In addition, it was found that the partitioning of hydrogen inhibits the graphite-steam reaction process even with the steam partial pressure up to 20.0 kPa. However, this inhibiting effect starts to become saturated when the hydrogen partial pressure exceeds 1.0 kPa. The oxidation rates were fitted to the conventional Langmuir-Hinshelwood (LH) and Boltzmann-enhanced Langmuir-Hinshelwood (BLH) models by a multivariable optimization algorithm. The BLH model exhibits a better accuracy than the LH model within the specified experimental conditions. The predicted oxidation rate using the BLH model shows a mean relative difference of about 24% with the maximum difference of about 55% when compared with our experimental data.