Experimental investigation on the influence of electrochemical machining parameters on machining rate and accuracy in micromachining domain

Abstract

Non-conventional machining is increasing in importance due to some of the specific advantages which can be exploited during micromachining operation. Electrochemical micromachining (EMM) appears to be a promising technique, since in many areas of application, it offers several special advantages that include higher machining rate, better precision and control, and a wider range of materials that can be machined. A better understanding of high rate anodic dissolution is urgently required for EMM to become a widely employed manufacturing process in the micro-manufacturing domain. An attempt has been made to develop an EMM experimental set-up for carrying out in depth research for achieving a satisfactory control of the EMM process parameters to meet the micromachining requirements. Keeping in view these requirements, sets of experiments have been carried out to investigate the influence of some of the predominant electrochemical process parameters such as machining voltage, electrolyte concentration, pulse on time and frequency of pulsed power supply on the material removal rate (MRR) and accuracy to fulfil the effective utilization of electrochemical machining system for micromachining. A machining voltage range of 6 to 10 V gives an appreciable amount of MRR at moderate accuracy. According to the present investigation, the most effective zone of pulse on time and electrolyte concentration can be considered as 10–15 ms and 15–20 g/l, respectively, which gives an appreciable amount of MRR as well as lesser overcut. From the SEM micrographs of the machined jobs, it may be observed that a lower value of electrolyte concentration with higher machining voltage and moderate value of pulse on time will produce a more accurate shape with less overcut at moderate MRR. Micro-sparks occurring during micromachining operation causes uncontrolled material removal which results in improper shape and low accuracy. The present experimental investigation and analysis fulfils various requirements of micromachining and the effective utilization of ECM in the micromachining domain will be further strengthened.