Experimental investigation on an innovative serpentine channel‐based nanofluid cooling technology for modular lithium‐ion battery thermal management

Abstract

AbstractMany nations have committed to becoming carbon neutral by 2050 as a means of addressing the global warming challenge. To achieve carbon neutrality, transportation is one of the most essential and important tasks. Energy‐efficient pure electric vehicles (EVs) and hybrid electric vehicles (HEVs) with green energy power are being developed in response to the worldwide energy and environmental crises, as the potential replacements for the current generation of combustion‐engine automobiles. EVs require batteries more than ever before. In this perspective, lithium‐ion batteries (LIBs) stand out as remarkable energy storage technologies and have been widely used due to their numerous impressive benefits. Owing to LIBs sensitivity to temperature, EVs typically use the battery thermal management system (BTMS). The working temperature span of a lithium‐ion battery in an electric car is 15°C–35°C, which is achieved by the use of a BTMS. The production of internal heat during charging and discharging also affects how well lithium‐ion batteries work. A battery heat control system is therefore required. The temperature of the LIB pack might be efficiently controlled by liquid‐cooled systems in discharge and charge scenarios. Based on Al2O3 nanofluid (NF), the current experimental study suggests a novel active cooling technology for regulating the heat produced by the 18650‐format lithium‐ion batteries. A thorough analysis is conducted on the impact of charge/discharge C‐rates, Al2O3 nanoparticle (NP) volume fractions, inflow coolant velocity, and intake liquid temperature on the thermal efficiency of the LIB pack. By incorporating aluminum oxide NPs into the water at varying volume fractions of 0.3%, 0.5%, and 1%, the LIB pack's maximum temperature was significantly reduced by 7.9%, 18.09%, and 19.56%, respectively. With increase in mass flow rate of coolant from 0.0290 to 0.5810 kg/s, the maximum temperature has been substantially reduced by 3.7%–8.6%. Results show that using higher fluid inflow temperature significantly increased both the highest experienced temperature and temperature diversity throughout the discharge operation by about, 6°C and 5°C, respectively. The outcomes of the study indicate that NFs exhibit superior cooling performance compared to conventional coolants such as water and ethylene glycol.