Experimental and numerical investigations of tip clearance flow and loss in a variable geometry turbine cascade

Abstract

Variable geometry turbines are widely employed to improve the off-design performance of gas turbine engines; however, there is a performance penalty associated with the vane-end partial gap required for the movement of variable vanes. This paper is a continuation of the previous work and aims to understand the leakage flow and loss mechanisms under the influence of the pivoting axis. Experimental investigations with a variable geometry turbine linear cascade have been conducted for tip gap heights of 1.1% and 2.2% blade spans as well as setting angles of −6°, 0°, and 6°, so as to reveal the three-dimensional clearance flow characteristics associated with partial gaps. Besides, numerical predictions are also carried out to better understand the experimental results. Pressure measurements were performed on the tip endwall as well as on the vane surface, and three-dimensional clearance flow fields downstream of the variable cascade were measured with a five-hole probe. The results show that as the vane setting angle is changed from design to closed, the vane loading increases and tends to be more aft-loaded, thus increasing the tip leakage loss, and vice versa. There are strong interactions between the flow around the pivoting axis and the leakage flow in the vane tip rear part, which leads to a low-pressure region on the tip endwall. The leakage vortex core is made up of the leakage flow in the vane tip rear part at both two tip gap heights, and the leakage vortex core formation process is different from the one in the rotor blade. The present results can provide useful references for the vane-end clearance design of variable geometry turbines.