Abstract
In this experimental study, an attempt is made to obtain optimum cutting parameters for turning of mild steel on the basis of surface roughness and surface temperature. Optimization of cutting parameters is very important to obtain a good machining quality of surface and to inhibit the increase of temperature. Minimum Quantity Lubrication (MQL) has been introduced to avoid excessive use of cutting fluid. The parameters considered here are cutting speed, feed and depth of cut. Optimal cutting parameters for each performance measure were obtained employing Taguchi experimental method. To study the performance characteristics in turning operation Analysis of Variance (ANOVA) was employed. It is found that cutting speed and feed has significant effect on both surface roughness and temperature.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Journal of University of Shanghai for Science and Technology
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
