Estimation and monitoring of grid connected PV system generation

Abstract

Listen

Translate article

This paper presents a new method to identify the operating performance parameters of a photovoltaic (PV) generator and a grid connected inverter. This method has been applied to the behavior modeling and simulation of the grid connected PV system at the Centre de Developpement des Energies Renouvelables (CDER) in Algeria. The PV module (PVM) parameters has been identified in static with outdoor measurements of I-V curves in order to model the PV array generation. Using the Linear Reoriented Coordinates Method (LRCM), the prediction of maximum power point (MPP) of the PV array has been performed without using complicate approximations or Taylor series. In order to estimate the ac output power, a PV inverter performance model based on empirical relationship was used. However, an accurate identification of the inverter performance parameters is performed using an optimization algorithm, named Levenberg-Marquardt (LM) algorithm, and a moutput current and voltage. The simulation results were achieved through MATLAB/Simulink environment, for the setting and the testing of the models. The results show a good agreement between the measured and estimated results based on the identified parameters. The integration of the proposed method and the presented model present a simple way to estimate the expected system performance with a high degree of accuracy. This solution allows a development of automatic supervision, energy generation prediction and fault detection procedure.