Abstract
In this paper, a multi-band RF energy harvesting circuit is designed. The output voltage and power of the system built at 900 MHz, 1800 MHz and 2450 MHz frequencies are revealed. All simulations in this paper are made using the Advance Design System (ADS) 2017 program. The load resistances that give the maximum power for each frequency are determined and the appropriate load is selected for all three frequencies. Then, the multi-stage Dickson Voltage Multiplier (DVM) from two to six stages is designed and the number of stages giving the maximum power for each frequency is determined using the selected load. L type and π type impedance matching have been applied to obtain the maximum output power in DVM design, which includes this number of stages and has two Schottky diode models (HSMS-2852). Finally, these three circuits are combined and the output voltage and efficiency of the resulting system are analyzed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Aksaray University Journal of Science and Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.