Abstract
In the paper, the results of experimental investigations of ion implanted cutting tools performance are presented. The tools, made out of Si3N4 with additives typically used for turning of Ti-6Al-4V alloy, underwent implantation with ions of yttrium (Y+) and rhenium (Re+) using the metal vapor vacuum arc method. Distribution of ions on the tool surface was measured. The cutting tools were tested in turning process with measurement of cutting forces and analysis of wear. A rather unexpected result was the increased wear of the tool after Y+ implantation with 1 × 1017 ion/cm2. It was demonstrated, however, that the tool after Y+ 2 × 1017 ion/cm2 ion implantation provided the best machining performance.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
