Abstract
In the present paper, transient liquid phase (TLP) bonding of Inconel 617 alloy under the different furnace atmospheres of vacuum, argon gas, and air was investigated. The experiments were carried out at 1408 K (1135 °C) for 300 minutes by using BNi-1 filler metals with different thicknesses of 50 and 100 µm. The microstructure, chemical analysis, shear strength, and microhardness of the resultant joints were studied. After 300 minutes, complete isothermal solidification was obtained for both the interlayers having 50 and 100 µm thicknesses under all the furnace atmospheres. The specimens bonded under vacuum condition showed the highest shear strength, failure energy, and ductility. Also, the joint produced under argon gas atmosphere using 100-µm-thick filler metal showed a good strength and may be acceptable in many applications. However, the specimens bonded under air atmosphere were weak, due to their further cavities and non-dissolved carbides. The presence of non-dissolved carbides in the diffusion-affected zone resulted in increasing the hardness of the base metal near the interface. The carbides were dissolved and the hardness of the diffusion-affected zone was reduced under vacuum condition compared to argon and air atmospheres. The best result was obtained for the specimen joined using the 50-µm-thick interlayer under vacuum atmosphere, with about 95.8 pct joint efficiency.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.