Abstract

6FDA-based polyimide air-dehumidification membrane has been considered as one of the most advanced technologies for the energy-saving heating, ventilation, and air-conditioning systems due to their excellent solubility and processing. Nevertheless, there are few reports about the effect of free volume and hydrophilic groups on dehumidification performance. Herein, we propose to tune the free volume and hydrophilicity of 6FDA-based polyimides by tuning the hydrophilicity/hydrophobicity of diamines and/or introducing of hydrophilic carboxylic acid groups, and thus to develop a system that would support high H2O/N2 separation performance for dehumidification and retain excellent mechanical properties. It is found that 6FDA/mPDA membrane shows much higher H2O/N2 separation performance (i.e., H2O permeability 12480 Barrer and H2O/N2 separation factor of 13867) than that of the 6FDA/TFDB and 6FDA/DAM membranes even though its lower FFV. It is suggested that the FFV had a negligible effect on the H2O/N2 separation performance. Although the introduction of highly hydrophilic –COOH groups could significantly increase the H2O/N2 separation performance of hydrophobic 6FDA/TFMB and 6FDA/DAM membranes, the performance is still lower than that of 6FDA/mPDA membrane with similar hydrophilicity. In addition, we found that more –COOH groups to polymers can lead to the possible formation of hydrophilic/hydrophobic separation in membrane which will result in the rapid water vapor condensation and thus unstable air-dehumidification. Thus, the excessive hydrophilicity of 6FDA/mPDA-DABA showed a decreased H2O/N2 separation performance compared with 6FDA/mPDA membrane. These results indicated that the excellent H2O/N2 separation performance mainly depends on reasonable hydrophilicity of polyimide membrane without excessive hydrophilic groups and high FFV.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call