DLP-printed standard tooth -colored ceramic dentures and its biocompatibility study

Abstract

Currently, ceramic dentures are mainly obtained by using computer-assisted cutting block of material to obtain the shape as the removing a model of patient's mouth. Followed by immersion coloring, porcelain stacking, and sintering to obtain dentures similar to a patients' tooth, this is a large-loss and complex process. In this study, 16 standard tooth samples were successfully reduced by adding Fe2O3, Pr6O10, Er2O3, and MnO2. After the colorful ceramic powder and photosensitive resin were configured into a slurry, a close to the sample tooth dentures was successfully prepared using digital light processing (DLP). The flexural strength and compressive strength of the ceramic specimens prepared by this method reached 821.01 ± 51.72 MPa and 2.67 GPa ± 0.22 MPa. To verify the biosafety of the prepared ceramics, we performed an in vitro biological evaluation of rat fibroblasts (L929). The resulting showed that the extracts of the prepared ceramic teeth had good biosafety, and the cells could also attach to the surface of the prepared ceramics. Hemolysis experiments confirmed good blood compatibility. Thus, our results show that DLP-printed standard tooth-colored ceramic dentures have good mechanical properties and biocompatibility, and can provide a solution to patients seeking quick access to aesthetic dentures.