Direct immobilization of Se(IV) from acidic Se(IV)-rich wastewater via ferric selenite Co-precipitation

Abstract

The attenuation of acidic Se(IV)-rich wastewater, including those associated with acid mine drainage (AMD) and nonferrous metallurgical wastewater (NMW), presents a serious environmental challenge. This study investigates the effects of diverse factors from pH values to Se(IV)/Fe(III) molar ratios, initial Se(IV) concentrations, and alkali neutralization agents on the direct co-precipitation of ferric selenites in AMD and NMW systems involving different orders of Fe(III) and alkali addition. Our results show that amorphous sulfate-substituted ferric (hydrogen) selenite and Se(IV)-bearing ferrihydrite-schwertmannite are the major Se(IV)-attenuation solids except that gypsum is an additional phase in the NMW system with Ca(OH)2 neutralization. Produced ferric selenites achieve 98–99.8% of Se(IV) immobilization under optimal conditions of pH 4.5, Se(IV)/Fe(III) molar ratios of 0.0625–0.5, and initial Se(IV) concentrations of 0.15–1.3 mmol·L-1. Moreover, completing FeSO4+ and FeHSeO32+/FeSeO3+ complexes as well as different ferric selenite co-precipitates are shown to collectively control aqueous Se(IV) remaining. Specifically, three distinct trends of aqueous Se(IV) concentrations separately correspond to changes in the four factors. The co-precipitation in the NMW system via pH adjustment followed by Fe(III) addition is more efficient for Se(IV) fixation than that in the AMD system because of minimal complexation, concurrent Fe(III) hydrolysis, and enhanced ferric selenite co-precipitation in the former.