Abstract
The technology for manufacturing of composites based on polymer (epoxy) resins and shungites was developed by using of the electron irradiation and experienced samples with different percentages of the components a) 90 and 10%, b) 70 and 30%, c) 50 and 50%, were manufactured respectively. It was carried out the series of experimental studies of the structure and properties of the obtained materials, including the atomic force microscope images were obtained and Raman spectra of these composites were measured and their analysis was performed.
Highlights
It is known from the literature that carbon materials have a high mechanical strength
The experimental technique We have developed the technology for manufacturing of composites based on polymer resins and shungites, which includes the following steps: 1. The choice of powder on the basis of shungit
The technology for manufacturing of composites based on epoxy resins and shungites with the use of electron irradiation was developed
Summary
Series: Materials Science and Engineering 81 (2015) 012004 doi:10.1088/1757-899X/81/1/012004. A I Kupchishin1*, M K Nauryzbaev[2], A A Kupchishin[1], F F Komarov[3], G E Remnev[4], N A Voronova[1], M Kaykanov[4 1] Abai Kazakh National Pedagogical University, Almaty, Kazakhstan 2 Al-Farabi Kazakh National University, Almaty, Kazakhstan 3 Belarusian State University, Minsk, Belarus 4 Research Tomsk Polytechnic University, Tomsk, Rassia
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have