Development of sweetness sensor with selectivity to negatively charged high-potency sweeteners

Abstract

Objectivetaste evaluation has been much in demand in the food, beverage and pharmaceutical industries. A taste-sensing system, which is an electronic tongue with “global selectivity,” is one of the methods used for objective taste evaluation. A taste sensor electrode responds to only one of the basic tastes (saltiness, sourness, sweetness, bitterness and umami) as a change in membrane potential caused by interactions with tastants. Sweet substances are compounds with diverse chemical structures and sizes. Since the taste-sensing system is a potentiometric measurement system using a change in membrane potential, three types of sweetness sensors are required, one for sweeteners with each type of electric charge (uncharged, positively charged and negatively charged). A sweetness sensor for uncharged sweeteners has been developed. Therefore, negatively charged sweeteners, such as saccharine sodium and acesulfame potassium, were chosen as the target substances in this study. We investigated the responses of various sensor membranes using a lipid and nine kinds of plasticizers to each basic taste sample. Furthermore, not only the selectivity of the membranes but also the concentration dependence of their response to sweeteners was investigated. As a result, one of the developed sensors showed responses of over 20mV to 5mM saccharine sodium and 10mM acesulfame potassium in CPA value measurement (CPA: change in membrane potential caused by adsorption). On the other hand, the sensor also showed nearly zero responses to other basic taste samples. In addition, saltiness was the only interfering taste, and the responses to target substances in relative value measurement were over 140mV. The developed sweetness sensor had high selectivity and concentration-dependent responses. Hence, we concluded that the sensor is suitable for use as a sweetness sensor for high-potency sweeteners with a negative electric charge.