Abstract
In the recent years the development in communication systems requires the development of low cost, minimal weight and low profile antennas that are capable of maintaining high performance over a wide spectrum of frequencies. This technological trend has focused much effort into the design of a microstrip patch antenna. The objective of this paper is to design an microstrip line fed rectangular microstrip patch antenna which operates in C-band at 5GHz. Therefore, method of moments based IE3D software is used to design a Microstrip Patch Antenna with enhanced gain and bandwidth. IE3D is an integrated full-wave electromagnetic simulation and optimization package for the analysis and design of 3D and planar microwave circuits, MMIC, RFIC, RFID, antennas, digital circuits and high speed Printed Circuit Board (PCB). The IE3D has become the most versatile, easy to use, efficient and accurate electromagnetic simulation tool. The length of the antenna is nearly half wavelength in the dielectric it is a very critical parameter, which governs the resonant frequency of the antenna. In view of design, selection of the patch width and length are the major parameters along with the feed line dimensions. Desired patch antenna design was simulated by IE3D simulator program. The entire project is being carried out at National Atmospheric Research Laboratory (NARL), ISRO.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have