Abstract
A broadband conical double-ridged horn (DRH) antenna with symmetrical radiation patterns, low side lobe level, and low cross polarization is presented. Experimental investigations and detailed simulations are conducted to understand its behavior and to optimize for broadband operation. Good agreement between the measurement and simulation has been achieved. The designed conical DRH antenna introduces a low voltage standing wave ratio (VSWR), which is lower than 2.3 for the frequency range of 6–18 GHz and simultaneously achieves slant polarization as well as stable far-field radiation characteristics in the entire operating bandwidth. The common impedance exponential tapering is used at the flare section of the horn. Moreover, a new cavity back with a conical structure is used to improve the VSWR. The simulated and measured results for VSWR, far field E-plane and H-plane radiation patterns, and gain of the designed antenna are presented and discussed. © 2011 Wiley Periodicals, Inc. Int J RF and Microwave CAE, 2011.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal of RF and Microwave Computer-Aided Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
