Critical condition for initiation of dynamic recrystallisation in electron beam powder bed fused Ti-6Al-4 V Alloy

Abstract

Despite the unique capabilities of Additive Manufacturing (AM) processes for producing Ti components with complex geometries, the desired properties are only achievable if a holistic scheme is devised, considering the synergistic role of post-processing steps. This work aimed to enhance the applicability of metal AM products by improving the process chain in the manufacturing industry. For this purpose, the current work demonstrates a comprehensive investigation into the hot deformation of Ti-6Al-4 V (Ti64) pre-forms produced via the Electron Beam Powder Bed Fusion (EB-PBF) process focusing on the determination of critical conditions for initiating Dynamic Recrystallization (DRX) in these components. Following a sequential evaluation procedure, hot deformation experiments were carried out at temperatures ranging from 1000 to 1200 °C and strain rates of 0.001–1 s−1 to determine the critical stress and strain required for initiating DRX in Ti64 pre-forms and compare them to their wrought counterparts. In addition, a specific Finite Element Model (FEM) was coupled with DRX kinetics equations to predict the volume percentage of DRX grains during the hot deformation of the pre-forms. The analysis of flow stress curves showed a significant peak stress at low strains, which is then followed by a period of flow softening and eventually transitions into a nearly steady-state flow at higher strains. In addition, compared to their wrought counterparts, the EB-PBF samples exhibited a significantly superior flow softening behavior, as evidenced by a more significant volume fraction of DRX and faster recrystallisation rates. It was also revealed that the normalised strain for DRX initiation in the EB-PBF Ti64 and wrought one was 0.55 and 0.67, respectively. FEM results closely matched the experimental finding, confirming its reliability in providing valuable insights into microstructural evolution and offering a time-efficient alternative for process design and property optimisation, lowering dependence on trial-and-error approaches. Through a combination of experiments, numerical analysis, and finite element simulations, this study sheds light on the macroscopic deformation and microstructural transformations occurring during hot working processes.