Concepção de um sistema de automação e monitoramento para equipamento utilizado em ensaios de trilhamento elétrico e erosão

Abstract

<p>This paper aimed at the design and development of a data acquisition and control system using the Arduino open-source platform to automate equipment responsible for the IEC 60587 electrical tracking and erosion test. The developed system allows the selection of protection resistors specified by the standard from the voltage value informed by the operator, monitoring of the leakage current flowing over five samples simultaneously tested and automatically interrupts the samples if the leakage current exceeds 60 mA for more than two seconds. The leakage current values are measured indirectly from the voltage drop across 50 Ω shunt resistors installed in series with each sample. The voltage values on the shunt resistors are conditioned by a measuring circuit that allows the voltage level to be adjusted to the analog inputs of the microcontroller, ie, between 0 V and 5 V. The microcontroller treatment performs the voltage signal obtained by the measuring circuit, the calculation of the RMS value of the current and stop criterion monitoring the leakage current. The calibration of the leakage current measurement circuit was performed by comparing voltage values measured by a digital oscilloscope for four different alternate waveforms and values up to 5 Vrms, corresponding to currents up to 100 mA. The results showed that the circuit provided measurements close to the values measured by the oscilloscope, with errors below 11%. For current values between 30 mA and 80 mA, the errors were less than 6%.</p>