Comparison of sample preparation procedures of inductively coupled plasma to measure elements in dog's hair.

Abstract

The pre-treatment condition affects on the element analysis of inductively coupled plasma (ICP). In this study the pre-treatment condition of ICP has been studied to quantify elements in dog’s hair. The hair samples were collected from twelve female Beagles by clipping them into 1 or 2 cm at the back neck. The qualitative and quantitative analysis of elements in hairs were performed by using ICP. By ICP nine elements were qualitatively detected and quantitatively analyzed (Ca, Cu, Fe, K, Mg, Na, P, Se, Zn). The measured amounts of elements were compared between 3 step and 2 step procedures which were with and without the acetone based washing step. The quantitative analysis showed that the concentrations of K, Na, P, and Se were significantly decreased in hair samples with acetone-based washing (p < 0.005 or 0.001) unlike those without the acetone-based washing. It implied that some minerals are lost by the acetone based washing during the sample preparation step. Therefore, the acetone based washing process is not suitable for quantifying elements in dog’s hair. In addition, the results of qualitative and quantitative analysis were compared. Although there was a difference in absolute values of elemental contents in hair, the results of qualitative and quantitative analysis were significantly correlated each other. This finding suggested that the results of qualitative analysis can be used to monitor elemental contents in dog’s hair.