Comparison of Liquid Phase Sintering and Cu-Melt Infiltration Methods to Consolidate 80W-Cu Composite Using Nickel as Sintering Activator

Abstract

In this article, studies were conducted to evaluate the densification of W-Cu sintered compacts produced using two methods; liquid phase sintering (LPS) and combination of liquid phase sintering and liquid infiltration technique (LPS+LI) named Cu-melt infiltration (Cu-MI). Low concentration of nickel (1wt.%) was used to activate the sintering process in both methods. Isothermal sintering was carried out in alumina tube furnace at temperatures of 1150°C for 2 hr. under H2/Ar. as protective gas. The infiltration (Cu-MI) method proved to be effective in the densification, microstructure and hardness enhancement of the 80W-Cu compact as opposed to the other conventionally liquid phase sintered compacts. The relative densities of 80W-Cu-1Ni composites prepared by using insert method (Cu-melt infiltration) achieved 96.22% of theoretical density.