Abstract

Abstract. Liquid clouds form by condensation of water vapour on aerosol particles in the atmosphere. Even black carbon (BC) particles, which are known to be slightly hygroscopic, have been shown to readily form cloud droplets once they have acquired water-soluble coatings by atmospheric aging processes. Accurately simulating the life cycle of BC in the atmosphere, which strongly depends on the wet removal following droplet activation, has recently been identified as a key element for accurate prediction of the climate forcing of BC. Here, to assess BC activation in detail, we performed in situ measurements during cloud events at the Jungfraujoch high-altitude station in Switzerland in summer 2010 and 2016. Cloud droplet residual and interstitial (unactivated) particles as well as the total aerosol were selectively sampled using different inlets, followed by their physical characterization using scanning mobility particle sizers (SMPSs), multi-angle absorption photometers (MAAPs) and a single-particle soot photometer (SP2). By calculating cloud droplet activated fractions with these measurements, we determined the roles of various parameters on the droplet activation of BC. The half-rise threshold diameter for droplet activation (Dhalfcloud), i.e. the size above which aerosol particles formed cloud droplets, was inferred from the aerosol size distributions measured behind the different inlets. The effective peak supersaturation (SSpeak) of a cloud was derived from Dhalfcloud by comparing it to the supersaturation dependence of the threshold diameter for cloud condensation nuclei (CCN) activation measured by a CCN counter (CCNC). In this way, we showed that the mass-based scavenged fraction of BC strongly correlates with that of the entire aerosol population because SSpeak modulates the critical size for activation of either particle type. A total of 50 % of the BC-containing particles with a BC mass equivalent core diameter of 90 nm was activated in clouds with SSpeak≈0.21 %, increasing up to ∼80 % activated fraction at SSpeak≈0.50 %. On a single-particle basis, BC activation at a certain SSpeak is controlled by the BC core size and internally mixed coating, which increases overall particle size and hygroscopicity. However, the resulting effect on the population averaged and on the size-integrated BC scavenged fraction by mass is small for two reasons: first, acquisition of coatings only matters for small cores in clouds with low SSpeak; and, second, variations in BC core size distribution and mean coating thickness are limited in the lower free troposphere in summer. Finally, we tested the ability of a simplified theoretical model, which combines the κ-Köhler theory with the Zdanovskii–Stokes–Robinson (ZSR) mixing rule under the assumptions of spherical core–shell particle geometry and surface tension of pure water, to predict the droplet activation behaviour of BC-containing particles in real clouds. Predictions of BC activation constrained with SSpeak and measured BC-containing particle size and mixing state were compared with direct cloud observations. These predictions achieved closure with the measurements for the particle size ranges accessible to our instrumentation, that is, BC core diameters and total particle diameters of approximately 50 and 180 nm, respectively. This clearly indicates that such simplified theoretical models provide a sufficient description of BC activation in clouds, as previously shown for activation occurring in fog at lower supersaturation and also shown in laboratory experiments under controlled conditions. This further justifies application of such simplified theoretical approaches in regional and global simulations of BC activation in clouds, which include aerosol modules that explicitly simulate BC-containing particle size and mixing state.

Highlights

  • Natural and anthropogenic atmospheric aerosol particles cause a global cooling of the Earth’s surface, partially compensating for the warming caused by greenhouse gases (Boucher et al, 2013)

  • This latter effect was shown for diesel soot coated with secondary organic aerosol in a laboratory study by Tritscher et al (2011) and for atmospheric Black carbon (BC) mainly coated with organic compounds (Kuwata et al, 2009)

  • Only limited data on BC properties have been published at the Jungfraujoch so far (e.g. Liu et al, 2010; Kupiszewski et al, 2016), but a more comprehensive manuscript on this topic is currently in preparation (Motos et al, 2019)

Read more

Summary

Introduction

Natural and anthropogenic atmospheric aerosol particles cause a global cooling of the Earth’s surface, partially compensating for the warming caused by greenhouse gases (Boucher et al, 2013). It increases the size and the hygroscopicity of the BC-containing particle, decreasing its critical supersaturation, i.e. the minimum supersaturation required for a particle to activate to a droplet This latter effect was shown for diesel soot coated with secondary organic aerosol in a laboratory study by Tritscher et al (2011) and for atmospheric BC mainly coated with organic compounds (Kuwata et al, 2009). Lund et al (2017) performed global model simulations testing the sensitivity of radiative forcing to the assumed threshold amount of coating needed for a BC-containing particle to be transferred from the unactivated to the activated mode Varying this threshold resulted in changes of up to 25 %–50 % in ari-induced radiative forcing compared to the baseline simulation. Alongside a better knowledge of the preindustrial concentrations of BC, the accurate simulation of the criteria required for activation together with realistic timescales for coating acquisition will help to reduce the uncertainties related to the radiative forcing of BC

Methods
Results
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call