Abstract

This study proposes a charging/discharging system of energy storage devices (ESDs) to regulate the voltage of a dc bus. The proposed charging/discharging system is formed by a zeta/sepic converter and a sliding mode controller (SMC). The SMC uses a single sliding surface to regulate the dc bus voltage for the three operating modes of the charger/discharger converter (charging, discharging, and stand-by) and for ESD voltages lower, equal, or higher than the dc bus voltage. This study includes the stability analysis of the SMC and a design procedure of the SMC parameters. The charging/discharging system is simulated in PSIM, where the results confirm that the proposed SMC regulates the bus voltage in charging, discharging, and stand-by modes for different operating points of the system. Finally, the proposed charging/discharging system was constructed for demonstrating the feasibility of the solution for real applications. Moreover, the experimental results obtained in such a platform put into evidence the accuracy of the proposed SMC in regulating the bus voltage in all the possible conditions: bus voltage lower, equal or higher than ESD voltage, and during charge, discharge, and stand-by modes of the ESD.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.