Abstract
ABSTRACTThis study describes the use of a steam environment to reflow phosphosilicate glass (PSG) samples using a HEATPULSE® rapid thermal annealer. The samples comprised PSG over poly steps and of open contacts in PSG. It was observed that reflow occurs 50°C lower in steam than in dry O2. An acceptable flow cycle for 8 w/o P in PSG glass is 1050°C for 10 seconds in steam, while for 6 w/o P PSG it is 1100°C for 10 seconds. Steam is found to be an effective amibient for densification of the PSG film. The thermal oxide grown in the contact during opening reflow was determined to be near 140 A. The operating regime for a junction depth <0.4 um and a reflow angle < 75° is presented for 8 w/o P.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
