Abstract
This paper describes the study on flexible connections application in IR detector package. Such a connection is used between two modules in single package. One module is IR detector operating at -73 °C, other is electronic controlling circuit operating at room temperature. Flexible electrical connection must provide good electrical parameters in both DC and RF regime as well as poor thermal conductivity. 35 μm epoxy-phenolic foil with 5 μm Ni film and special RF compatible Ground-Signal-Ground geometry was successfully applied as connection. Low eutectic temperature InSn solder was used for soldering flexible connection to both IR detector and electronic circuit. Two types of soldering processes were investigated: bump and lap type. Flexible connection was tested for DC operation with long term stability test and RF parameters were determined. Authors found that both joining techniques are suitable for application in IR photodetector devices. However lap type joint is easier to apply in technological process, therefore it will be applied in final assembly.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IOP Conference Series: Materials Science and Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
